Table of Contents
Advertisement
3.3 Switch 5: CDMA Modulation
A different calibration table is needed for CDMA operation. Turn on switch 5 for
CDMA use.
CDMA
All other
3.4 Switch 6, 7, and 8: Downlink Peak Power Limit
For initial power-up, turn all these switches "off". See Appendix B for full details.
This completes the configuration switch settings. Leave the cover off so adjustments
can be made later if needed.
4.0 Installing the EkoMini
Only qualified technicians should perform the installation. The user is cautioned that
modification or changes to this device not expressly approved by EMS Wireless
could void the user's authority to operate this equipment.
TM
The EkoMini
is designed for indoor use only. It should not be mounted outside.
• Determine the donor and server antenna(s) locations. Choose a
location for the EkoMini
these antennas, while maintaining adequate isolation. Also choose
a protected area such as an electrical or telephone room so the
EkoMini
be near a 100 - 240 VAC, 47 – 63 Hz outlet. See Figures 3 and 4
below – do not apply AC power without the coaxial cables and
antennas installed!
reconnect the DC power cable after the antennas are
connected. This will initiate a software reset.
Modulation
TM
:
TM
will not be physically damaged. The location must also
Switch 5 Position
On
Off
TM
that will minimize coaxial cable lengths to
If this is done, disconnect and then
Advertisement
Table of Contents
