Appendix A: Manually Reducing the Uplink Gain
If excessive noise is received in the BTS uplink receiver during repeater use, the
repeater uplink signal may be too strong. Up to 6 dB attenuation of the repeater UL
signal may be inserted by toggling switches 1 and 2 according to the table below.
Note:
This manual control overrides the automatic set-up software.
unbalances the UL gain relative to the DL gain.
UL Gain Offset
Relative to DL
0 dB
-2 dB
-4 dB
-6 dB
Be sure to press the "reset" button to make these changes effective.
Switch 1 Position
Off
On
Off
On
Switch 2 Position
Off
Off
On
On
It also