Bios Settings; General Information; Entering Setup - WinSystems ITX-N-3815-1-0 Product Manual

9.

BIOS Settings

9.1

General Information

9.2

Entering Setup

v1.0
The ITX-N-3800 includes a uEFI BIOS from Phoenix Technologies stored in Flash ROM.
Access setup information through the BIOS setup utility to modify basic system
configuration. The configuration is stored in CMOS RAM (it is retained during power-
off). When power is applied to the system, the ITX-N-3800 communicates with
peripheral devices and checks hardware resources against the configuration
information stored in the CMOS memory. If during startup an error is detected or the
CMOS parameters need to be initially defined, the diagnostic program prompts the user
to enter the SETUP program. Some errors are significant enough to cause the startup to
fail.
To enter setup, apply power to the computer and then press F2. This key (F2) must be
pressed when either the splash screen is displayed (during the system power-on self
test, POST) or when the Press F2 for Setup message is displayed. It may take a few
seconds before the main setup menu screen is displayed.
Press F2 to enter SETUP
If the message disappears before responding and you still wish to enter Setup, restart
the system by pressing the RESET button. It can be also restarted by pressing the Ctrl,
Alt, and Delete keys on the keyboard simultaneously.
Press <F1> to Run General Help or Resume
The BIOS setup program provides a General Help screen. The menu can be easily called
up from any menu by pressing F1. The Help screen lists all the possible keys to use and
the selections for the highlighted item. Press Esc to exit the Help screen.
www.winsystems.com
ITX-N-3800/BIOS Settings
Page 28