Lautsprecher Teufel 1. Invoice number GmbH. Can be found on the sales slip No part of this user manual may...
Page 4
NOTICE Check that all items have been delivered and that nothing is damaged. If you find any damage, do not operate the device; instead contact our customer service department. • Reflect...
– Make sure that the wall mounting is done in a professional manner. – In case of a wall mounting, verify the carrying capacity of the walls and make sure that there are no cables or pipes in the drilling areas. • Reflect...
Page 6
(e.g. control tors. knobs or plug adapters). They could swallow the parts and choke. – Never allow children to operate electrical equipment unsupervised. • Reflect...
You can hand old electrical devices from penetrating the housing. over to the local reusable materials/ recycling centre. Please contact your vendor directly for more information about this topic. • Reflect...
Unpacking • Carefully open the box, take out the EPE foam half-shell and carefully lift the speakers out of the box. Package contents (1) 2x Reflect ceiling speaker (2) 2x mounting plate (3) 4x screw Checking the package contents • Check that all items have been delivered and that nothing is damaged.
Dolby Atmos Satellite speakers Conventional Surround Sound You can also use the Reflect speakers systems generate surround sound as normal satellites (e.g. as a 2.1 in a horizontal direction. With Dolby or a 5.1 system). The toggle (4) on Atmos systems, sound is also...
Mounting plate You can install the mounting plate (2) in two positions so that can set up the Reflect speaker in an upright position or on its side. • To set up the speakers on existing speakers, the bottom of the mounting plates is fitted with a non-slip rubber layer.
• 2 screws, 4 x 45 mm, screw head = ø approx. 8 mm Setup CAUTION Set up the Reflect speakers in an Risk of injury/damage! upright or lateral position onto the – Only qualified persons may existing speaker boxes. The Reflect...
Page 12
6. Press the Reflect speaker up against the wall so that the screws fit into the keyhole openings (5). 7. Now pull the Reflect speaker down so that the screws slip into the small slot. 8. If applicable, screw the screws...
To 1. Lay speaker cables from your AV facilitate this, the individual receiver to each Reflect speaker. If possible, use high-quality dual core single wires of the speaker speaker cables with a diameter of...
• Use a damp cloth to rub off stub- born dirt. Make sure that no liquid penetrates the housing. • Then immediately wipe the damp surfaces off with a soft cloth without applying pressure. • Reflect...
Technical Data Dimensions (WxHxD) without mounting plate 130 x 85.5 x 184 mm Weight 1.45 kg You can find further technical data on our website. Technical changes reserved! • Reflect...
Page 16
Please contact our customer service department with any questions, suggestions, or complaints: Lautsprecher Teufel GmbH BIKINI Berlin Budapester Straße 44 10787 Berlin (Germany) Phone: 00800 200 300 40 (toll-free) Fax: +49 (0)30 / 300 930 930 Online support: www.teufelaudio.com/service Contact form: www.teufelaudio.com/contact No responsibility is assumed for the correctness of this information.