Bosch Greentherm T9800 SEC 199 Installation And Operating Instructions Manual page 9

Technical characteristics
Width
Height
Net weight
Gross weight
Electrical
Voltage
Frequency
Amperage (Idle)
Amperage (operation)
9)
Water protection
Table 3
1) These flow are based upon setting the unit to higher temperatures and then mixing down using cold water after the unit, to reach
these flow rates.
2) Input rating is based on sea level operation and need not be changed for operation up to 2000 ft (610 m) elevation. For
operation at elevations above 2000 ft (610 m), input rating is automatically reduced at the rate of 4 percent for each 1000 ft
(305 m) above sea level.
3) When converted to LPG the minimum input is 17 000 BTU/hr (5 kW).
4) With constant flow.
5) Can be reprogrammed to achieve up to 140 °F (60 °C) (see chapter 6.4).
6) Requirements: Steady flows, single unit installations, up to 140 °F (60 °C).
7) To measure Gas Pressure, see Measuring Gas Pressure, chapter 4.13, page 39.
8) Refers to activation point. Deactivation point value is 0.35GPM (1.3 l/min).
9) Protection against water drops.
Safety devices
• Flame failure device (flame detection via ionization rod)
• Overheat prevention
• Inlet water temperature sensor
• Outlet water temperature sensor
• Exhaust flue gas temperature sensor
• Water flow sensor
• Air flow sensing technology (Optiflow)
• Scaling detection sensor (HE flue gas temperature sensor)
Greentherm T9800 SE 160/199 | SEC 199
Units Greentherm T9800 SE / SEC
199 000 Btu
19
inches (mm) 18
inches (mm) 31½ (800)
pounds (kg) 77.5 (35.2)
pounds (kg) 89.95 (40.8)
V AC
Hz
mA
A
IP
Greentherm T9800 SE
/ (471.5)
32
120
60
40
 2,7
X4D
Appliance details | 9
160 000 Btu
19
18 / (471.5)
32
31½ (800)
73.2 (33.2)
85.54 (38.8)
120
60
40
 2,7
X4D
6 720 816 815 (2018/08)