Activate Communication Between El 1Xx And Visiwinnetâ Smart - Lenze EL 103 ECO PLC Operating Instructions Manual

7 Commissioning
Establish Ethernet connection
Activate communication between EL 1xx and VisiWinNet
7.3.2 Activate communication between EL 1xx and VisiWinNet
The following settings are required if you wish to transmit a VisiWinNET
the EL 1xx via Ethernet. They are not required to establish a general TCP/IP connection.
How to proceed:
)
Note!
If an autostart of the Remote Access Manager is specified in the VisiWinNET
Control Panel Applet (¶ 43), the VisiWinNET Remote Access dialogue is
displayed automatically after starting the HMI.
Proceed as follows if that dialogue is not displayed:
ƒ
ƒ
ƒ
1. Activate the Commandhandler Registry in the VisiWinNET Remote Access Dialogue.
2. If the TCP/IP control field is selected and the status is displayed as Running,
communication has been enabled. Elsewise, proceed as follows:
3. Select the TCP/IP control field.
4. Click Start.
The status changes to Running. TCP/IP communication has been enabled.
5. Click Save to store this setting.
,
See VisiWinNET
information on project transmission.
34
Start ® Programs ® Windows Explorer
Folder Flashdisk/VisiWinNET
Double−click the VisiWinNET.RemoteAccessManager Application.
â
Smart software manual, Getting Started, for further
l
â
Smart
â
Smart
â
Smart project to
LDCDS−EL100 EN 8.0
â
EL100−020