Rear Panel - Samson S63, S83 Manual

Guided Tour - S63 Rear Panel
POWER
o
ON
1
OFF
FUSE
2
120 VOLT 6 AMP
220 VOLT 3.5 AMP
8
POWER RATING
120V/60Hz 450 W
3 4
5
EFFECT RETURNS S6 MIXER AMPLIFIER
EFFECT SENDS
+4dB
1 2 1
+4dB
47K
600
+4dB
+4dB
600
10K
AMP IN PRE AMP OUT 2
CAUTION
!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
MON OUT
SPEAKER OUTPUT
MINIMUM 2
6 7
1: Power switch - As you may have guessed, this is what you use to turn the
S63 on and off. The built-in protection relay circuitry (which mutes the outputs for
approximately five seconds after powering on) prevents power-on "thumping,"
which can potentially damage connected speakers.
2: Fuse holder - Insert a 6 amp fuse here for 120 volt operation. Insert a 3.5
amp fuse here for 220 volt operation.
3: Effect Returns - These unbalanced inputs allow you to route signal from
external devices such as effects processors to the Effects Return section of the
S63. Because the S63 is a monophonic system, stereo signals input to the pair
of Effects returns 1-2 are automatically mixed to mono. See the "Using the
Effects Sends and Returns" section in this manual for more information.
4: Effects Sends - These unbalanced outputs allow you to route signal from
each of the two discrete Effects Sends to external devices such as effects
processors. Effects Send 1 is pre-fader and pre-EQ, while Effects Send 2 is
post-fader and post-EQ. See the "Using the Effects Sends and Returns" section
in this manual for more information.
6 CHANNEL 210 WATT 4 SAMSON TECHNOLOGIES CORP., HICKSVILLE, NEW YORK
9
14
TO PREVENT SHOCK,
DO NOT OPEN. NO USER
SERVICABLE PARTS
INSIDE. REFER SERVIC-
ING TO QUALIFIED SERVICE
PERSONNEL. TO PREVENT
FIRE OR SHOCK HAZARD
DO NOT EXPOSE TO RAIN
OR MOISTURE
CAUTION
HEATSINK MAY BE HOT!
DO NOT BLOCK AIRFLOW
OR OVERHEATING MAY
OCCUR
SERIAL NUMBER
ASSEMBLED
IN R.O.K.