Table of Contents
Advertisement
S 1 0 0 0 / S 7 0 0
P
O
AMPLIFIER
-40db
-20db
CLIP
S1000
-30dB
500W X 2 STEREO
-80dB
-40db
-20db
CLIP
S700
-30dB
350W X 2 STEREO
-80dB
OWNERS MANUAL
W
-20dB
OFF
ON
PROTECTION
POWER
PROTECTION
-10dB
-30dB
o
CHANNEL 1
CHANNEL 2
-80dB
0dB
-20dB
OFF
ON
PROTECTION
POWER
PROTECTION
-10dB
-30dB
o
0dB
CHANNEL 1
CHANNEL 2
-80dB
E
R
-20dB
-40db
-20db
CLIP
-10dB
SAMSON
0dB
-20dB
-40db
-20db
CLIP
-10dB
SAMSON
0dB
®
Advertisement
Table of Contents
Related Manuals for Samson S1000
Summary of Contents for Samson S1000
- Page 1 S 1 0 0 0 / S 7 0 0 AMPLIFIER -20dB -20dB -40db -20db CLIP PROTECTION POWER PROTECTION -40db -20db CLIP S1000 -30dB -10dB -30dB -10dB 500W X 2 STEREO SAMSON -80dB CHANNEL 1 CHANNEL 2 -80dB -20dB -20dB...
-
Page 2: Table Of Contents
S700 / S1000 Features 2 Guided Tour 3 Front Panel 3 Rear Panel 4 Setting Up and Using Your S700 / S1000 5 The S700 / S1000 Protection Circuitry 6 Bridged and Parallel Modes 7 S700 / S1000 Connections 8 Specifications 10 FRANÇAIS... -
Page 3: Introduction
Fan-cooled for maximum thermal protection, the S700 delivers 350 watts of power per channel (or, in Bridged mode, 700 watts), and the S1000 provides a whopping 500 watts of power per channel (or, in Bridged mode, 1000 watts), over the full frequency spectrum, from 10 Hz to 55 kHz. Combination connectors allow both balanced XLR and balanced 1/4"... -
Page 4: S700 / S1000 Features
The Samson S700 / S1000 power amplifier utilizes the latest technology in professional power amplifier design. Here are some of its main features: • Power to spare - In the S700, each channel delivers 350 watts of power into 4 ohms. In the S1000, each channel delivers 500 watts of power into 4 ohms. -
Page 5: Guided Tour
2: Power LED - Lights whenever the S700 / S1000 is powered on. 3: Protection LED - This goes on for approximately five seconds whenever the S700 / S1000 is powered on and then turns off (you’ll hear a “click” when it does so). The Protection LED will also light when overheating or other severe problems occur (see page 6 in this manual for more information). -
Page 6: Rear Panel
Make sure that both the front and rear panels are kept free of all obstructions and that cool, fresh air is accessible at all times. Also, try to ensure that the S700 / S1000 is used in a dust-free environment. -
Page 7: Output Bridge (8 ~16 )
PROTECTION Protection LED will go off (you’ll hear a click when this occurs). 7. Apply an input signal to the S700 / S1000 at or about 0 dBu (if sending signal from a Protection LED mixer, drive the output meters at approximately 0 vu). While the input signal is present, slowly raise the Channel Input controls until the desired sound level is achieved. -
Page 8: The S700 / S1000 Protection Circuitry
• Shorted speaker cables: This will occur if, due to faulty wiring, the hot and ground signals being output by the S700 / S1000 short one another. • Output impedance drops below 2 ohms: This can occur if the S700 / S1000 is connected to inappropriate speaker systems (see the “Setting Up and Using Your S700 / S1000”... -
Page 9: Bridged And Parallel Modes
Bridged and Parallel Modes The S700 / S1000 provides a rear-panel switch that allows it to be used in either a Bridged or Parallel mode. When this switch is placed in the “STEREO” BRIDGED PARALLEL (center) position, the S700 / S1000 functions as a true stereo amplifier, where... -
Page 10: Input
S700 / S1000 Connections The illustrations on these two pages show the required interconnections when using the S700 / S1000 in Stereo, Bridged and Parallel modes. Wiring for Speakon™ connectors (shown on the right) is indicated where appropriate. Stereo Mode:... -
Page 11: Push To Reset 20A / 250V
(4 ohm min) (4 ohm min) (4 ohm min) (4 ohm min) Using the S700 / S1000 Link Connectors The illustration belows shows how multiple amplifiers can be interconnected using the S700 / S1000 link connectors. INPUT OUTPUT PUSH TO RESET BRIDGE... -
Page 12: Specifications
Stereo / Parallel modes S700, per channel (into 4 ohms) 360 W S700, per channel (into 8 ohms) 230 W S1000, per channel (into 4 ohms) 545 W S1000, per channel (into 8 ohms) 340 W Bridged mode S700, per channel (into 8 ohms)