Front And Rear Panel Layout; Powering S Direct Plus - Samson S-direct plus Owner's Manual

1 2 3
LEFT INPUT - 1/4" input connector.
1
LEFT OUTPUT/LINK - 1/4" output for LEFT OUTPUT/LINK - 1/4" output for
2 2 2 LEFT OUTPUT/LINK
passing the input signal through to a
stage amplifier or monitor system.
LEVEL SWITCH - When engaged, the
3
level is switched from instrument GTR to
amplifier speaker SPK level.
RIGHT INPUT - 1/4" input connector.
4
RIGHT OUTPUT/LINK - 1/4" output for RIGHT OUTPUT/LINK - 1/4" output for
5 5 5 RIGHT OUTPUT/LINK
passing the input signal through to a
stage amplifier or monitor system.

Powering S direct plus

The S direct plus can operate on a single 9 Volt battery or standard 24-48 volt phan-
tom power. Whenever phantom power is present on the XLR cable that is connected
to the Balanced Output, the S direct plus will automatically switch to phantom power
and disconnect the 9 Volt battery. In fact, when the Battery switch is in, the S direct
plus will sense the voltage and chose which ever is greater. The Phantom/Battery
switch can be used to turn off the battery power when the unit is not in use.
4 5
S direct Front and Rear Panel Layout
� � �
BATTERY COMPARTMENT - Houses
A
a standard 9 Volt Battery.
GROUND LIFT - When the switch is
B
engaged, the input ground (shield)
is disconnected from the S direct
plus circuit ground.
RIGHT BALANCED OUTPUT - Male
C
XLR connector.
LEFT BALANCED OUTPUT - Male
D
XLR connector.
BATTERY/PHANTOM - Switches S
E
direct plus from phantom power to
battery operation.
3
� �