Connecting The Usb Cable - Tascam US-322 Quick Start Manual

MULTI TRACK mode
At the same time that each input enters the mixer, their
signals are sent by separate channels to the computer.
They are output in stereo from the mixer, however, so
they can be listened to using speakers or headphones.
Example: Use with a DAW or similar software
Mic Guitar
MIC LINE/GUITAR
Mixer
US-366
STEREO MIX mode
Each input is sent to the mixer, and the stereo output
of the mixer is sent by USB to the computer. In
addition, the mixer output can also be listened to
using speakers or headphones.
Example: Use for live Internet broadcasts
Mic Guitar
MIC LINE/GUITAR
Mixer
US-366

Connecting the USB cable

After completing the above settings, connect the USB cable.
CAUTION
USB 1.1 is not supported.
Making driver software settings
Press the MIXER PANEL button on the top of the unit (see the
next item) to open the mixer panel on the computer display.
INTERFACE screen settings
The mixer panel has three screens that can be selected by their tabs.
Select the "INTERFACE" tab to open the following "INTERFACE" screen.
1 Sample Clock Source
Usually, this should be set to "Automatic".
Game device
Computer
DIGITAL
USB
PHONES
Headphone
Game device
Computer
DIGITAL
USB
Live Internet
broadcast
PHONES
Headphone
2 Digital Output Format
Usually, this should be set to "S/PDIF". Change this setting when
necessary to use "AES/EBU" with, for example, pro equipment.
For details about the other settings, please refer to the
Owner's Manual.
Listening to the input signal
1 INPUT 1/2 knobs
Use the knobs for each input (INPUT 1/L and INPUT 2/R)
to adjust their levels. Set them so that their overload (OL)
indicators do not light.
2 MON MIX knob
Use to adjust the balance between the sound input through
this unit and the sound sent from the computer by USB.
3 PHONES knob
Use to adjust the level output from the (PHONES)
headphones output jack.
4 SIG indicators
These light when a signal (of −30 dBFS or more) is input
through the corresponding channel.
5 OL indicators
These light just before the input signal distorts (when it
exceeds −2 dBFS).
6 MIC/LINE-GUITAR switch
When a guitar or bass, for example is connected to the
LINE/GUITAR input jack, set this to GUITAR. Otherwise,
set it to MIC/LINE.
7 LINE OUT knob
Use to adjust the level output from the line output (OUT
1/L and OUT 2/R) jacks.
8 USB indicator
This lights when the USB connection is normal.
9 48V indicator
When the 48V switch is set to 48V, this indicator lights.
0 48V switch
Use this switch to enable phantom power to the mic
input connector. When the 48V switch is set to 48V, 48V
indicator above it lights.
q MIXER PANEL button
Press this button to open the mixer panel on the
computer display.
CAUTION
•
Before turning a 48V switch ON or OFF, turn the output
volume down using the PHONES and LINE OUT knobs on
the front panel. Depending on the mic, loud noises might
be produced and damage could be caused to equipment
or to people's hearing.
5
TASCAM US-322/US-366