Installation - Mitsubishi Electric PAR-SL100A-E Installation Manual

2 &RQ¿ UPLQJ WKH 6XSSOLHG 3DUWV
&KHFN WKDW WKH ER[ LQFOXGHV WKH IROORZLQJ SDUWV LQ DGGLWLRQ WR WKLV LQVWDOODWLRQ PDQXDO
Parts Name
Wireless remote controller
Remote controller holder
$$ /5 DONDOLQH EDWWHU\
Tapping screws 3.5 × 16
Only use AA batteries (LR6). Replace low batteries with new AA batteries (LR6). Observe the polarity of the batteries as indicated, and insert the
QHJDWLYH HQG ¿ UVW

3 Installation

8VH WKH UHPRWH FRQWUROOHU KROGHU WKDW LV SURYLGHG WR DYRLG PLVSODFLQJ WKH UHPRWH FRQWUROOHU
,QVWDOO WKH UHPRWH FRQWUROOHU LQ D ORFDWLRQ WKDW PHHWV WKH IROORZLQJ FRQGLWLRQV
‡ 2XW RI WKH GLUHFW VXQ OLJKW
‡ $ZD\ IURP DQ\ KHDW VRXUFHV
‡ 2XW RI WKH DLUIORZ IURP WKH DLU FRQGLWLRQHU FRRO RU ZDUP
‡ :KHUH WKH RSHUDWLRQ RI WKH UHPRWH FRQWUROOHU FDQ HDVLO\ EH SHUIRUPHG DQG WKH GLVSOD\ LV UHDGLO\ YLVLEOH WR
the user
‡ 2XW RI WKH UHDFK RI VPDOO FKLOGUHQ
NOTES:
,I WKHUH LV D IOXRUHVFHQW OLJKW LQ WKH URRP LQ ZKLFK WKH DLU FRQGLWLRQHU LV WR EH LQVWDOOHG WXUQ LW RQ DQG PDNH
sure that the signal from the remote controller can be received by the indoor unit from the intended instal-
lation location. When the signal receiving unit receives a signal from the remote controller, a short beeping
sound will be heard.
,I WKH DLU FRQGLWLRQHU XQLW LV LQVWDOOHG LQ D URRP LQ ZKLFK D À XRUHVFHQW OLJKW RQ DQ HOHFWURQLF OLJKWLQJ FRQWURO
system (i.e., inverter light) is installed, signal interference may occur.
* Maximum signal receiving distance is approximately 7 meters (Approx. 22 feet). Signal receiving angle is
approximately 45 degrees to the right and the left from the center.
* Install the unit at least 1 meter (Approx. 3 feet) away from the TV or radio.
(If the unit is installed too close to these appliances, signal interference (picture distortion and noise) may
occur.)
8VH WKH WDSSLQJ VFUHZV WKDW DUH SURYLGHG WR PRXQW WKH UHPRWH FRQWUROOHU KROGHU RQ WKH ZDOO DQG WKHQ SODFH
the remote controller in the holder.
1. Remove the top cover, insert two LR6 AA batteries, and then
install the top cover.
1
Top cover
3
Quantity
1
1
2
2
2
Two LR6 AA batteries
Insert the negative (–) end of each
EDWWHU\ ¿ UVW ,QVWDOO WKH EDWWHULHV LQ
the correct directions (+, –)!
2. Press the Reset button.
object that has a narrow end.
C
B
A
A Remote controller
B Wall
C Display panel
2