Battery Installation (Remote Control) - Magnavox MTFT716n Owner's Manual

BATTERY INSTALLATION (REMOTE CONTROL)

Battery installation:
Install or replace the batteries as follows:
1. Press the tabs on the battery door and lift it off.
2. Install two (2) x AAA size batteries (included) into the
battery compartment as the figure on the right and
the polarity markings inside battery compartment.
3. Replace the battery door.
Battery Precautions:
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the battery
compartment. A reversed battery may cause damage to the device.
3. Do not mix different types of batteries to gether (eg.Alkaline and Carbon-zinc) or old
batteries with fresh ones.
4. If the batteries in the device are consumed or the device is not to be used for a long period
of time, remove the batteries to prevent damage or injury from possible battery leakage.
5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture.
(Follow battery manufaturer's directions.)
6. Do not dispose of battery in fire. Battery may explode or leak.
7. Clean the battery contacts and also those of the device prior to battery installation.
Remote Control Sensor
1. When there is an obstacle between the unit and the transmitter, the transmitter may not operation.
2. When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light shines on the remote
control of the unit, the remote operation may be unstable.
15 Feet (5M)
LCD ON/OFF STANDBY
MENU
OK
N/P
TITLE
GOTO
- 9 -