GE IC695CNM001 Quick Start Manual page 11

Two steps are required to configure the IC695CNM001 module as a
master on a CANopen network:
1. Configure the CANopen network using SYCON.net and
download the configuration to the CNM001 module through the
USB port.
The CNM001 master module must be configured as node 1.
The slave devices are configured as nodes under the master
module.
Notes: If the Configuration command is unavailable when
you right click the node containing the CANopen
Master, you must first select Disconnect, and then
select Configuration.
In the CANopen Master configuration screen, make
sure the netXDriver device driver is the only driver
selected. Clear all other driver selections.
GFK-2837 PACSystems* RX3i CANopen Master Module Quick Start 11