Installation In Hazardous Areas - GE IC695CNM001 Quick Start Manual

Pacsystems rx3i series canopen master module intelligent platforms programmable control products
Table of Contents

Advertisement

2.1. Installation in Hazardous Areas

The system containing the CNM001 module must be mounted
within an ultimate enclosure that can be accessed only by the use
of a tool.
The following information is for products bearing the UL marking for
Hazardous Locations or ATEX marking for explosive atmospheres:
EQUIPMENT LABELED WITH REFERENCE TO CLASS I,
GROUPS A, B, C & D, DIV. 2 OR ZONE 2 HAZARDOUS AREAS
IS SUITABLE FOR USE IN CLASS I, DIVISION 2, GROUPS A, B,
C, D, ZONE 2 OR NON-HAZARDOUS AREAS ONLY
WARNING – EXPLOSION HAZARD – SUBSTITUTION OF
COMPONENTS MAY IMPAIR SUITABILITY FOR CLASS I,
DIVISION 2 OR ZONE 2;
WARNING – EXPLOSION HAZARD – WHEN IN HAZARDOUS
AREAS, TURN OFF POWER BEFORE REPLACING OR WIRING
MODULES; AND
WARNING – EXPLOSION HAZARD – DO NOT CONNECT OR
DISCONNECT EQUIPMENT UNLESS POWER HAS BEEN
SWITCHED OFF OR THE AREA IS KNOWN TO BE
NONHAZARDOUS.
GFK-2837
PACSystems* RX3i CANopen Master Module Quick Start
7

Advertisement

Table of Contents
loading

Table of Contents