Burkert 0290 Operating Instructions Manual

Burkert 0290 Operating Instructions Manual

2/2-way solenoid valve
Hide thumbs Also See for 0290:

Advertisement

Quick Links

Type 0290
2/2-way solenoid valve
2/2-Wege Magnetventil
Electrovanne à 2/2 voies
Operating Instructions
Bedienungsanleitung
Manuel d'utilisation

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 0290 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Burkert 0290

  • Page 1 Type 0290 2/2-way solenoid valve 2/2-Wege Magnetventil Electrovanne à 2/2 voies Operating Instructions Bedienungsanleitung Manuel d‘utilisation...
  • Page 2: Intended Use

    OPERATING INSTRUCTIONS INTENDED USE The operating instructions contain important information. Incorrect use of the solenoid valve Type 0290 can be dangerous ▶ Read the operating instructions carefully and follow the safety to people, nearby equipment and the environment. instructions in particular, and also observe the operating ▶...
  • Page 3: Basic Safety Instructions

    2.2 Approvals Risk of electric shock. Devices which bear the type approval mark were approved at the Kraft- ▶ Before reaching into the 0290, switch off the power supply and secure to prevent reactivation. fahrtbundesamt under the type approval number ▶...
  • Page 4: Warranty

    ▶ The device may only be used in the explosion-protected area if an The operating instructions and data sheets for type 0290 can be found appropriate additional identification is attached to the type label. → Type 0290 on the internet at: www.burkert.com...
  • Page 5 Permitted medium temperature depending on seal material and Operating principle 2/2-way valve: coil model: 2 (A) 2/2-way valve, Seal material Model with High-power Model without elec- (NC) direct-acting, normal output A coil or rectifier AC/DC* tronics 50 Hz, 60 Hz* unloaded 1 (P) -10...+80 °C...
  • Page 6 Permitted media depending on seal material: Electrical operating conditions With high-performance elec- Without Seal material Permitted media tronics AC/DC electronics Neutral media, compressed air, water, hydraulic oil 50 Hz, 60 Hz Per-solutions, hot oils Ambient tem- max. +70 °C max. +55 °C EPDM Oil and grease-free media e.g.
  • Page 7 Intermittent operation for version with high-performance electronics Permitted operating parameters AC/DC Characteristic values (according to DIN VDE 0580) – Cycle time – Duty cycle – De-energized pause ED – Relative duty cycle SH – Switching frequency Switching frequency 6/min [s] = 10/min 15/min ED[%]...
  • Page 8: Type Label (Example)

    Type 0290 A 20,0 FKM VA 4.2 Conformity Port connection, G 3/4 P N 0 - 16 bar In accordance with the EU Declaration of conformity, Type 0290 is com- 230 V 50 Hz 16 W pressure range pliant with the EU Directives (if applicable).
  • Page 9: Safety Instructions

    INSTALLATION 5.2 Before installation Installation position: Installation can be in any position. 5.1 Safety instructions Preferably: Actuator upright. DANGER! → Prior to installation check pipelines for dirt and, if required, clean. Dirt filter: To ensure that the solenoid valve Risk of injury from high pressure in the equipment. functions reliably, a dirt filter (≤...
  • Page 10: Electrical Installation

    NOTE! WARNING! Caution risk of breakage. Danger of electrical shock if the protective conductor contact • Do not use the coil as a lever arm. between the coil and body is missing. ▶ Always connect protective conductor. → Observe direction of flow: ▶...
  • Page 11: Maintenance & Troubleshooting

    MAINTENANCE, TROUBLESHOOTING Seal 6.1 Safety instructions Authorized cable plug e.g. Type 2508 or other suitable DANGER! cable plug in accordance with DIN EN 175301-803 Form A Risk of injury from high pressure in the equipment. ▶ Before loosening the lines and valves, turn off the pressure and max.
  • Page 12: Ordering Spare Parts

    6.2 Malfunctions SPARE PARTS If malfunctions occur, check whether: CAUTION! • the device has been installed according to the instructions, Risk of injury and/or damage by the use of incorrect parts. • the electrical and fluid connections are correct, Incorrect accessories and unsuitable spare parts may cause injuries and •...
  • Page 13: Packaging, Transport, Storage, Disposal

    7.2 Overview of replacement spare sets PACKAGING, TRANSPORT, SET 1 = coil set STORAGE, DISPOSAL SET 3 = wearing parts set NOTE! DN 32, DN 40, DN 12 DN 20, DN 25 Transport damages. DN 50, DN 65 Inadequately protected equipment may be damaged during transport.
  • Page 14 Fax + 49 (0) 7940 - 10 91 448 E-mail: info@buerkert.com International address www.burkert.com Manuals and data sheets on the Internet: www.burkert.com Bedienungsanleitungen und Datenblätter im Internet: www.buerkert.de Instructions de service et fiches techniques sur Internet : www.buerkert.fr © Bürkert Werke GmbH & Co. KG, 2013-2017 Operating Instructions 1702/10_EU-ML_00893124 / Original DE www.burkert.com...

Table of Contents