Trademarks; Introduction; Prerequisites; Getting Started - Texas Instruments CC3100 SimpleLink User Manual

CC3100 SimpleLink™ Wi-Fi
This guide is intended to assist users in the initial setup and demonstration of the Getting Started with
WLAN Station application. The guide explains how to install an Integrated Development Environment
(IDE), and then compile, download, and debug Getting Started with WLAN Station.
1

Trademarks

SimpleLink is a trademark of Texas Instruments.
Microsoft, Windows are registered trademarks of Microsoft.
Wi-Fi is a registered trademark of Wi-Fi Alliance.
2

Introduction

2.1

Prerequisites

The user should have the following items:
• One CC3100BOOST
• One CC31XXEMUBOOST or MSP430F5529 Launchpad
• An 802.11b/g/n Wireless Access Point (AP)
• A computer running Microsoft
3

Getting Started

3.1

Download and Install Software

Download and install the following software:
• CC3100 SDK package
– This guide assumes the use of the default installation folder C:\TI\CC3100SDK_<x.x.x>\. .
3.2

Update Service Pack

If the board is not already flashed with the service pack for SDK_<x.x.x>, the latest service pack for
SDK_<x.x.x> must be flashed on the CC3100. The latest service pack can be downloaded from
http://www.ti.com/tool/cc3100sdk. Refer to the UNIFLASH Quick Start guide for details on flashing the
service pack to the CC3100
(http://processors.wiki.ti.com/index.php/CC31xx_%26_CC32xx_UniFlash#Service_Pack_Programming).
Details on setting up the hardware for flashing can be found in
4
CC3100 SimpleLink™ Wi-Fi
ABSTRACT
Windows 7 or XP operating systems.
® ®
http://www.ti.com/tool/cc3100sdk
®
and IoT Solution Getting Started Guide
Copyright © 2014–2018, Texas Instruments Incorporated
SWRU375D – June 2014 – Revised May 2018
® and IoT Solution Getting
Started Guide
Section 4.1 .
SWRU375D – June 2014 – Revised May 2018
Submit Documentation Feedback
User's Guide