Exhaust Air Accessories - ergoline Prestige 1600 Planning Manual

Planning Manual

Exhaust air accessories

Connection to a central exhaust system is possible upwards, upwards right, upwards
left and to the rear.
The apertures intended for this purpose are located above the central exhaust air
bracket.
Corrugated pipe
Suitable device exhaust is possible with an exhaust pipe up to 10 metres in length (with-
out 90° bend). An auxiliary fan is required for exhaust pipes longer than 10 metres.
Smooth pipe
Suitable device exhaust is possible with an exhaust pipe up to 30 metres in length (with-
out 90° bend). An auxiliary fan is required for exhaust pipes longer than 30 metres.
Warm air recycling
Warm air recycling is a technically advanced, secure device which feeds part of the hot
cooling air back to the studio via a motor-controlled air choke. A thermostat provides
fully automatic control of the studio temperature, between 15 °C and 25 °C as required.
The exhaust air bracket and warm air recycling can also be retrofitted.
Item Accessory parts
Central exhaust air bracket, 
1
with warm air recycling, thermostatically con-
trolled including connector piece, see Item 4
Central exhaust air bracket, 
but without warm air recycling
2 90° Pipe bend in Brilliant Silver
3 Corrugated pipe ( 300 mm, 6 m length,
flexible, grey) including 2 pipe clamps
4 Corrugated pipe connector piece ( 300
mm)
5 Connector bracket for corrugated pipe (
300 mm)
6 Exhaust air adapter in black (not shown)
Article No. Notes
500000872 with connection possible for exhaust air pipes
( 300 mm) on the top, top right, top left and to the rear
500000873
100001292 for inlet and exhaust air ducting to right, left or to rear,
plus tube adapter for direct connection to central
exhaust air bracket [possible with tube ( 300 mm)]
34502800 –
34502700 for connecting two corrugated pipes
34503600 connection of the corrugated pipe, e.g. to a canal
34526600 for double rear wall
Prestige 1600
Prestige 1600 – 7