How To Install Your Canopy Housing; How To Assemble The Ceiling Fan Blades - Fanimation ZONIX MA4660SSBNW Manual

4. Once the connection has been made, slide the
receiver into the hanger bracket, taking care not to
pinch the wires. (Figure 5)
NOTE: This step is applicable after the neccessary
wiring is completed.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1. Carefully slide the blade through the slot. Securely
fasten the three blades with serrated-head screws with
flat washers. Do not over-tighten. (Figure 1)
NOTE: You will find the fan blade set packed in its own
carton and hardware bag in the fan box.
How to Wire Your Ceiling Fan (continued)

How to Install Your Canopy Housing

WARNING

How to Assemble the Ceiling Fan Blades

Hanger Bracket
Serrated-head
Screw with Flat
Washer (3 per blade)
HARDWARE USED:
Serrated Head
Screw
Flat Washer
11
Receiver
Figure 5
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
Blade
(Not included)
Figure 1
x 9
x 9