Internal Configuration - Welch Allyn 4200B Directions For Use Manual

3

Internal Configuration

You can change several device operating parameters in the Internal Configuration Mode.
When changed, these settings become the default power-up settings. You will also see
non-changeable device configurations for technical service purposes.
To enter the Internal Configuration Mode:
1. Turn the Spot Vital Signs off.
2. Press and hold the Power and Blood Pressure Start/Stop buttons. The device
enters the Internal Configuration Mode and displays the software version.
3. Press the Mode button to cycle through the Internal Configuration menu until you see
the menu option displayed on the screen.
4. Use the Next Patient/Clear/Cancel or Blood Pressure Start/Stop buttons to
change the default setting.
5. Press the Mode button once to save the change and press the Power button to exit
the Internal Configuration Mode.
Table 2. Configuration Menu Options
Setting
Blood Pressure Calibration
Displays "Cal"
Inflation Pressure Preset Level
Displays "PrP"
Pressure Preset Level
Displays "PrP"
Backlight
Displays "BLT"
Mean Arterial Pressure
Displays "MAP"
Date/Time
Temperature Scale
Displays "TMP MOD"
Blood Pressure Units
Displays "BP"
Battery Readings
Displays "BAT"
Battery Life
Displays "LFE"
Description
Prepares the Spot Vital Signs for calibration. Only qualified personnel should verify the
Spot Vital Signs blood pressure calibration. For more details, see "Checking the Blood
Pressure Calibration" on page 26.
120, 140, 160, 180, 200, 240, 280 mmHg. Factory default is 160 mmHg.
On or off. Disables or enables the front panel Pressure Preset button.
On or off.
On or off.
Changes or updates the actual date and time.
Fahrenheit (°F) or Celsius (°C) Normal Mode / Fahrenheit (°F) or Celsius (°C) Monitor
Mode
mmHg or kPa.
Displays the total battery voltage.
Total number unit measurements. Displayed information only; operator cannot change.
19