Fuse Replacement - iGenix IG9902 User Manual

Problem
The unit doesn't
seem to cool the
room down?
The unit is
noisy?
The compressor
doesn't work?
Remote control
doesn't work?
MAINS PLUG FUSE REPLACEMENT
Fuse Replacement (Class I)
This appliance must be eathed. Remove the fuse cover with a small
flat head screw driver. Take out the fuse and replace with a new fuse
of the same Amp. Replace the fuse cover and push back into place.
12
Cause
Is there direct sunshine
in the room?
Too many windows or
door open!
Is there something in the
room producing heat?
The filters are dirty!
Air inlets or outlets are
blocked!
Unit stands uneven!
The overheating
protection has activated!
The batteries are
drained!
Remote control signal
not being picked up by
the control panel!
Solution
Close any curtains or blinds.
Close a door or window to
reduce the loss of cold air.
Turn any heater etc. off.
Clean or replace filters.
Confirm that there is nothing
obstructing the inlets and outlets.
Ensure that the unit is standing on a
flat even surface.
Wait until the unit has cooled
down before trying again
Replace with new batteries.
Ensure you are not too far
away from the unit.
Make sure the remote control is
correctly aimed at the control panel.
Fuse Cover