iGenix IG9902 User Manual page 9

Setting Timer
• Press Timer button (Fig 13 [7]) to set the operating hours you require (1 to 12 hours, the Timer
Indicator (Fig 13 [6]) will show indicating that the function has been set. When the set time is
reached, the unit will automatically switch off.
• If you need to be reminded of the hour(s) that were set, press the Timer button (Fig 13 [7]) and
the time will show in the display window (Fig 13 [10]).
Important: If the timer is not set then the unit will work continuously.
• The Timer function can be pre-set for the unit to switch on when required. For example, press the
timer to 2 without setting any of the other functions and the unit will automatically switch on after
2 hours.
Sleep Function
• Press the Mode button (Fig 13 [5]) to select required function: Automatic, Cooling or Fan.
The indicator light of selected mode will show.
• In Cooling mode press the Sleep button, the set temperature will increase 1°C after the 1st hour,
another 1°C on the 2nd hour and then the temperature will remain consistent.
• In Heat mode press the Sleep button, the set temperature will decrease by 1°C after the 1st hour,
another 1°C on the 2nd hour and then the temperature will remain consistent.
• In Sleep mode the fan will stay on low speed. To return to the pre-selected mode press Sleep button
again.
• The unit will automatically switch off after the sleep function has been running for 12 hours.
Important: The sleep function is not available whilst the unit is on the Auto Fan (ventilation) mode.
Heating Function
• Press the Mode button (Fig 13 [5]) to select required function: Automatic, Cooling or Fan.
The indicator light of selected mode will show.
• The Heating Function uses the ambient warm air to heat the area where it is required. The Exhaust
Hose (Fig 3 [12]) must be fitted to allow cold air to be removed.
• Continuous Drain is optional whilst the unit is in heating mode. The operating temperature for
Heating function is from 7°C to 25°C. It is not recommended to operate the Heating function
outside this temperature range.
• This function can be used on the high (Fig 13 [13]) or low speed (Fig 13 [14]).
Remote Control
• All the above functions can also be performed with the supplied remote control
• Two AAA batteries are required to use the remote control.
• Point the remote control towards the control panel of the unit and press the relevant button.
• The airflow direction cannot be adjusted with the remote control.
Self-diagnosis
• This unit has a self-diagnosis function. If something is wrong with the unit the Display Window
(Fig 13 [10]) will show the word E1or E2.
• If either show's then please contact Pik-a-Pak Electrical Distributors, 38 Bluestem Road, Ransomes
Europark, Ipswich, IP3 9RR. Tel. 01473 271 272
• To prolong the life of the compressor, after switching the unit off, wait for 3 minutes before
switching back on.
9