Sharp AL-1600 Service Manual page 36

AL-1610
Main Sub
Contents
code code
22 16 Duplex print counter
display
17 Copy counter display
18 Printer counter display
19 Electronic sort counter
display
20 FAX print counter display
21 Scanner counter display
24 1 JAM memory, JAM
counter clear
2 Trouble memory clear
4 SPF counter clear
5 Duplex counter clear
6 Paper feed counter clear
7 Drum counter clear
8 Copy counter clear
9 Printer counter clear
10 Electronic sort counter
clear
11 FAX print counter clear
13 Scanner counter clear
25 1 Main motor operation
check
10 Polygon motor operation
check
26 1 Operation switch display
3 Auditor setting
∗1: Each counter display method
To display 12345: 123 (0.75 sec) → Blank (0.35sec) → 456 (0.75 sec) → Blank (1.0 sec) → repetition
∗2: Display after clearing each counter
000 (0.75 sec) → Blank (0.35sec) → 000 (0.75 sec) → Blank (1.05 sec) → Repetition
Details of operation
Used to display the current duplex print counter value. ∗1
Used to display the current copy counter value. ∗1
Used to display the current printer counter value. ∗1
Used to display the current electronic sort counter value. ∗1
Used to display the current FAX print counter value. ∗1
Used to display the current scanner counter value.
Used to clear the JAM memory and the JAM counter. ∗2
Used to clear the trouble memory. ∗2
Used to clear the SPF counter. ∗2
Used to clear the duplex counter. ∗2
Used to clear the paper feed counter. ∗2
Used to clear the drum counter. ∗2
Used to clear the copy counter. ∗2
Used to clear the printer counter. ∗2
Used to clear the electronic sort counter. ∗2
Used to clear the FAX print counter. ∗2
Used to clear the scanner counter.
Used to drive the main motor for 30 sec. At that time, the cooling motor
rotates at a low speed.
When the developing unit is installed, the developing bias, the grid, and
the main charger are driven.
When the developing unit is not installed, only the main motor is driven.
Used to drive the polygon motor for 30 sec.
Used to display the installed option on the operation panel. (The LED
corresponding to the installed option is lighted.)
Key operation
Display select: <Lighting with an option installed>
Magnification ratio key
When "A" is displayed:
Shifter: Paper empty LED
Job separator: JAM LED
SPF: SPF select LED
RSPF: SPF JAM LED
Dehumidifying heater: Main body JAM LED
Simplex mode: Multi manual paper feed select LED
When "B" is displayed:
Cassette (2nd step): No. 2 cassette select LED
Cassette (3rd step): No. 3 cassette select LED
Cassette (4th step): No. 4 cassette select LED
Memory installed: Paper empty LED
FAX: JAM LED
Printer: Main body JAM LED
ERDH: Main cassette select LED
16CPM: SPF JAM LED
20CPM: SPF select LED
Document sensor: Auto paper select LED
Used to display the current auditor setting with the numbers at right. After
entering the set value, press the start key, and the set value is stored.
Key operation/Display
0: Built-in auditor
1: Coin vendor
2: Others
8 – 6
Initial
value
Display
Set range