Sharp AL-1600 Service Manual page 16

AL-1610
11) Raise the handle of the paper tray and pull the paper tray out
until it stops.
12) Remove the pressure plate lock. Rotate the pressure plate lock
in the direction of the arrow to remove it while pressing down the
pressure plate of the paper tray.
13) Store the pressure plate lock which has been removed in step 5
and the screw which has been removed in step 2 in the front of
the paper tray.
•
To store the pressure plate lock, rotate the lock to fix it on the
relevant location.
Pressure
plate
lock
Screw
5 – 2
14) Push the pressure plate down until it locks in place.
15) Squeeze the lock lever of the front guide and slide the front
guide to match the width of the paper.
16) Move the left guide to the appropriate slot as marked on the
tray.
When using 11" × 17" copy paper, store the left guide in the
•
slot at the left front of the paper tray.
Left guide
17) Load copy paper into the tray.
•
Set the paper along the guides.
•
The tray holds up to 250 sheets of about 9kg bond paper.
Do not load paper above the maximum height line.
Maximum height line
18) Push the paper tray firmly back into the copier.
19) Ensure that the power switch of the copier is in the OFF position.
Insert the supplied power cord into the power cord socket at the
rear of the copier.
•
If you use the copier in a country other than the country
where the copier was purchased, you will need to make sure
that your local power supply is compatible with your model. If
you plug the copier into an incompatible power supply, ir-
reparable damage to the copier will result.
20) Plug the other end of the power cord into the nearest outlet.
•
Only insert the power cord into a properly grounded wall
socket.
Do not use extension cords or power strips.
Front guide