Using Digital Zoom; Usb Connection - Sight mark SIGNAL N320RT User Manual

USING DIGITAL ZOOM

The digital zoom function allows you to control the Signal's magnification. Each Signal
RT model is equipped with 2x digital zoom. When digital zoom is activated, the full
magnification value is shown on the display.
To activate the zoom function:
1. Press the digital zoom button (4).
2. Each consecutive press of the controller will cycle between the optical
magnification and the 2x zoom. For example, the 4.5x Signal will change to 9x
when the 2x digital zoom is applied.
Note: digital zoom is not saved in the unit's memory. Each time the unit is turned off and
back on, digital zoom is turned off and the magnification will be set to the optical magnification (i.e. 4.5x or 6x).
DISPLAY OFF FUNCTION
This function deactivates the display, which eliminates light exposure caused by the glowing display, but also saves battery
life when the unit is not being used for viewing.
To turn off the display:
1. Press and hold down the on/off button (4) for more than one second.
2. The display will turn off and will show the message "Display Off".
3. To turn the display on, briefly press the on/off button again.
Note: when the display off function is activated, all controls are inactive except for the on/off button. Remote viewing through
Wi-Fi feature will continue to function. Video recording also will continue if recording was activated before the display off
function was activated. Finally, the display off function will deactivate if the unit is connected to a PC via the USB port or to an
external power supply.
8

USB CONNECTION

ZOOM
The Signal RT can be connected to a PC via the USB port (8). The PC will detect
the Signal automatically, no driver installation is necessary. With the Signal turned
9x
01:42
on and connected to a PC, the display will show two icons: plug icon (power)
and computer icon (storage device). Use the navigation buttons (3,5) to change
between the two modes. press the zoom button (4) to select the desired mode.
USB Mass Storage Device
If this option is selected, the unit is detected by the PC as a storage device. The unit
switches to USB power and will not use up the AA batteries. This mode allows the
04:23pm transfer of recording videos and photos from the Signal RT's memory to the PC. In
this mode the unit's functions are deactivated.
Power
When this option is selected, the PC is used to power the unit. The external power icon appears on the display in place of
the battery charge icon. Typically, this mode is used with a power bank for longer operating times out in the field.
Connection in various operating modes
Connection Option
USB
Power
Operating Mode Status of the Unit
Video/Photo The unit is "off. "
If the video recording is on when the connection is
made, the recording is stopped and saved automatically.
Review The unit is "off. "
If a video is being reviewed when the connection is
made, review stops.
Video/Photo/Review The unit continues to function
960p 04:23pm
Active connection Inactive connection
option option
9