Toshiba BMS-SM1280HTLE Owner's Manual page 9

Smart Manager
H: Check code
I: Louver position/swing
J: Functions (1)
K: Functions (2)
L: Functions (3)
M: Central control
N:
O:
("Controller Prohibition" mark)
P:
Q:
("Operating" mark)
When the selected air conditioner is abnormal, its unit number and the check code are displayed.
Louver position or louver swinging is displayed. (When no remote controller is used.)
: Lights when the power saving mode is activated.
: Lights when a ventilation fan is running.
: Lights when the
: Displayed when functions of schedule (*) and return-back operation enabled
activated.
* (A separately sold weekly timer is required.)
: Indicates that filters should be replaced.
: Indicates that a test run is being executed.
: Displayed when the air conditioner cannot operate with the selected operation mode
(when heating and cooling modes are mixed in the multi- indoor unit control system).
: Displayed at the beginning of heating operation or during defrosting operation. While this
mark is displayed, the indoor fan stops.
: The selected operation prohibited setting (
displayed in the central control mode.
: Displayed when the central control system is controlling. When the
with remote controller operation disabled by the central control system,
Flashes for several minutes when the power switch is turned on. While this mark is flashing, no
setting is enabled because the Smart Manager is recognizing connected groups.
Lights while the controller prohibition function is activated. (While this mark is lighting, no operation
is enabled.)
* Pressing the , , and
OFF
.
Lights in the emergency stop state due to an alarm signal input. (Ex. fire alarm)
Lights when at least one controlled air conditioner is operating.
Flashes when at least one air conditioner is abnormal or the protective device is activated.
or button is pressed though the function is not provided.
SET TEMP.
, , , or
flashes and no setting change is accepted.
buttons simultaneously switches controller prohibition
Owner's Manual
CENTRAL
1, 2, 3, or 4) is
button is pressed
ON
/
EN
-EN
9