Qualcast 407635 Instruction Manual page 22

• Under certain conditions with the charger plugged into the power supply, the exposed
charging contacts inside the charger can be shorted by foreign materials. Foreign
materials of a conductive nature, such as, but not limited to, steel wool, aluminium foil,
or any build-up of metallic particles, should be kept away from charger cavities. Always
unplug the charger from the power supply when there is no battery pack in the cavity.
Unplug the charger before attempting to clean.
• Do not immerse the charger in water or any other liquid.
WARNING!
Don't allow any liquid to get inside the charger, as this may result in electric
shock. To facilitate the cooling of the battery pack after use, avoid placing the
charger or battery pack in a warm environment, such as in a metal shed or an
un-insulated trailer.
CAUTION!
Never attempt to open the battery pack for any reason. If the plastic housing of
the battery pack breaks or cracks, dispose of the battery pack in accordance
with local regulations; do not put it into further use.
Install the battery pack
Warning! Always release the On/Off switch before inserting or removing the
battery pack.
Remove the battery pack: Depress the button (A) on the end of the battery pack,
and then remove the pack from the tool.
Install the battery pack: Align the ribs on both sides of the battery pack with the
slots in the housing and slip it into place. Always insert it all the way until it locks
in place with a click sound.
If it's not correctly inserted, it may accidentally fall out of the tool, causing injury
to you or bystanders.
To release the battery from the product, push the button (A) on the battery pack
and pull away from the product.
22