Nice TTP Instructions And Warnings For Use page 8

4.4.3) Cancelling the memorized positions
A previously memorized position can be cancelled by following the relevant procedure described in Table 14, Table 15 or Table 16.
Table 14 Cancelling position 0
1. Press the key for position 0. The LED on the key flashes.
2. Press the 'Cancel' key (bin). The LED on the key flashes.
3. The green OK LED flashes: press OK within 3 seconds to confirm.
4. On completion of the operation, the LED on the key for position 0 flashes.
Note: on motors for shutters, cancelling position 0 also cancels the data for the other positions.
Table 15 Cancelling position 1
1. Press the key for position 1. The LED on the key flashes.
2. Press the 'Cancel' key (bin). The LED on the key starts flashing.
3. The green OK LED flashes: press OK within 3 seconds to confirm.
4. On completion of the operation, the LED on the key for position 1 flashes.
Note: cancelling position 1 also cancels the intermediate position.
Table 16 Cancelling the intermediate position
1. Press the key for the intermediate position. The LED on the key flashes.
2. Press the 'Cancel' key (bin). The LED on the key flashes.
3. The green OK LED flashes: press OK within 3 seconds to confirm.
4. On completion of the operation, the LED on the key for the intermediate position flashes.
4.5) Programming torque reduction (RDC)
Some motors are equipped with a "torque reduction" (RDC) function. If the RDC function is activated, the respective LED lights up, other-
wise it remains OFF. If the function is not available for the type of motor connected, the key on the TTP is not active.
Table 17 Enabling/disabling torque reduction
1. Press the RDC key.
2. The green OK LED starts flashing: press OK within 3 seconds to confirm.
4.6) Programming the wind protection intervention threshold
You can quickly change the wind sensor intervention threshold by following the procedure described in Table 18.
Table 18 Selecting the wind protection intervention threshold
1. Press the key repeatedly until the LED corresponding to the desired threshold lights up.
2. The green OK LED starts flashing: press OK within 3 seconds to confirm.
Note: The number of levels available depends on the motor connected; if the motor accepts 3 thresholds, therefore, the LEDs which light
up in sequence are 1 2
4.7) Programming the sun protection intervention threshold
You can quickly change the sun sensor intervention threshold by following the procedure described in Table 19.
Table 19 Selecting the sun protection intervention threshold
1. Press the key repeatedly until the LED corresponding to the desired threshold lights up.
2. The green OK LED starts flashing: press OK within 3 seconds to confirm.
Note: The number of levels available depends on the motor connected; if the motor accepts 3 thresholds, therefore, the LEDs which light
up in sequence are 1 2
8
3 1etc.
3 1 etc.
Example
3s
Example
3s
Example
3s
Example
3s
Example
3s
Example
3s