Nice TTP Instructions And Warnings For Use page 6

4.1.3) Searching for the motor
Once the TTP is switched on, if you briefly press the ON/OFF key, the unit starts searching for any motor that may be connected. During the
search (which may last several seconds) the orange OK LED flashes slowly. On completion of the search, if a motor is recognised, the LEDs
for the functions available for programming light up. If no motor is detected, the error is indicated by an acoustic signal.
Table 6 Searching for the motor
1. Press the ON/OFF key
2. The OK LED starts flashing slowly.
3. Wait for the end of the search:
• If the motor is detected, the green OK LED and the LEDs for the functions available
for programming light up
• If the motor is not detected, the unit emits 2 short beeps and only the red OK LED
lights up
Note: you can interrupt the search at any time by pressing the ON/OFF key again.
4.2) Motor movement keys
The , and keys are the equivalent of the keys on the transmitter and perform the functions set out in Table 7.
Table 7 Movements
1. Press
2. Press
3. Press
4. Press
move to the set position.
4.3) Programming the direction of movement
For motors with mechanical limit switch, you can quickly change the direction of movement of the motor by following the procedure described
in Table 8.
Table 8 Programming the direction
1. If no direction has been programmed, the
and the LEDs above the
2. Press the key for the direction you want.
3. The green OK LED starts flashing: press OK within 3 seconds to confirm.
4. On completion of the operation, the LED on the key corresponding to the direction you
have chosen will light up.
Note: after programming the direction of movement, check that the
awning, and that the key closes the shutter or pulls down the awning.
If the devices do not operate in the direction you want, first cancel the direction and then reprogramme with the opposite direction.
To cancel the direction, proceed as described in Table 9.
Table 9 Cancelling the direction
1. Press the 'Cancel Direction' key.
2. The green OK LED starts flashing: press OK within 3 seconds to confirm
3. On completion of the operation, the LEDs above the
at very brief, regular intervals.
In order to control motor movements after cancelling the direction, it is necessary to repeat the procedure described in Table 8.
4.4) Programming the positions
On motors with electronic limit switch, functions are available for quick programming of positions 0
been set, the corresponding LED lights up, otherwise a short flash indicates that it has not yet been programmed.
6
; the motor starts the UP manoeuvre.
; the motor stops the manoeuvre.
; the motor starts the DOWN manoeuvre.
and simultaneously; if an intermediate position has been set, the motor will
and keys flash simultaneously at very brief, regular intervals.
and keys do not control motor movements
key on the transmitter does in fact open the shutter or pull up the
and keys flash simultaneously
Example
Example
+
Example
or
Example
, 1 and I . If a position has already
3s
3s