Advertisement
EN
NL
Adjusting height
handles firmly before using the rollator.
the maximum height adjustment of the
pushing handles, your rollator will not
be stable anymore.
The pushing handles can be adjusted in
height by following steps (figure 4):
•
Loosen knob (2) for height adjustment.
•
Remove the knob completely.
•
Remove the bolt (11) from the tube.
•
Adjust the pushing handles to the
desired height (6 different positions).
When standing straight, the handles
should be as high as your wrists. Leave
your arms hanging loose.
•
Place bolt (11) back in the hole of the
tube.
•
Place knob (2) on bolt (11).
•
Tighten knob (2) firmly by hand.
•
Adjust the other pushing handle with
the same instructions.
•
Check that the two pushing handles are
adjusted with the same height.
Figure 4: Adjusting the push handles
2
Risk of falling
CAUTION
Secure
Risk of falling.
CAUTION
Do not exceed
11
Brake system
the
working of the pression brakes and the
wear of the end pieces to ensure your
safety.
The rollator is equipped with pression
brakes. To apply the brakes, just use your
weight on the pushing handles of the
rollator (figure 3).
If the user sits on the seat of the rollator, the
pression brakes are automatically applied.
When using this rollator remind that the
stability depends on all wheels being in
contact with the ground. It should therefore
only be used on flat and firm surfaces.
Using the rollator on other floors, surfaces
or on slopes will considerably reduce its
stability.
Storage bag
CAUTION
Do not overload the storage bag.
The storage bag is meant to be mounted
below the seat.
Mount the storage bag with the snap
fasteners (12) on the two horizontal tubes
where the seat rests on.
The maximum carrying weight of the
storage bag can be found in the table of §6.
Figure 5: Storage bag
2
EN - 4
Risk of falling.
CAUTION
Check the
Risk of falling,
tipping over
Cadeo
2017-11
12
Advertisement
