Whirlpool Cassinetta Repair Manual Line page 25

Side by side electronic refrigerator

Table of Contents

At the end of the Built-in Test it is possible to reset to "0" the Water Filter Indicator and/or

Antibacterial Filter Indicator in the following way:

Water Filter Indicator Factory/Service reset

Press 4 times consecutively (within 10 sec) the Water valve shaft switch.

The symbol "F" on the Refrigerator display shall be shown in order to confirm the operation.

Antibacterial Filter Indicator Factory/Service reset

Press 4 times consecutively (within 10 sec) the Refrigerator Compartment door switch.

The symbol "A" on the Refrigerator display shall be shown in order to confirm the operation.

Built-In Test check code (User Interface operation)

The check code will be displayed on the Fridge display. Every check will have the related check

code that will be the same as the sequence number foreseen during the Built-in Test.

ERROR TYPE

Components (Relay Damper)

Evaporator De-Frost heater

Fridge probe

Freezer probe

Evaporator fan

Compressor fan

Damper

Water valve dispenser

Ice valve

Ice Maker Sankyo

OPERATION TYPE

Water Filter Indication reset

by Service/Factory

Antibacterial Filter Indication

reset by Service/Factory

If 2 or more errors code have been recognized these codes shall be displayed on fridge

display in a rolling way (each code will persist about 1 second till the Built-in Test will be

stopped).

ERROR

CODE

Displayed on 1 digit Fridge display

OPERATION

CONFIRMED

CODE

Displayed on 1 digit Fridge display

NOTE

Table of Contents