Table of Contents
Advertisement
The icemaker water valve will be automatically controlled and driven by the
The flow rate for the icemaker water valve is:
Opening time of the icemaker water valve is:
Ice valve ALARM indication for opening time: < 20 seconds
Water pressure range with filter cartridge:
Water pressure range without filter cartridge:
Supply voltage ( nominal ) :
Motor power dissipation :
Ice production per day :
Condition to start ice production:
Condition to stop ice production:
The ice cube extracting will be managed only by twisting (no heating element inside).
The "Ice-Full" arm turns every 2 hours in the down position (30°C). In this case the
internal contact inside of the icemaker, gave a signal to the main board. The signal means,
that the ice production can go ahead. If the arm can't go complete down, while the ice cube
doesn't allow this, the feedback signal is missing and the ice production will be stopped.
The icemaker check can be done only with the "Built-In test routine"!!
CONNECTOR OUTPUT PINS & INTERNAL WIRING DIAGRAMM
4 BROWN
3 YELLOW
2 BLUE
1 BLACK
ICE – WATER VALVE MANAGEMENT:
Main Board!
GENERAL REQUIREMENTS:
12V
8 W
0,8kg
-9°C ambient temperature for min. 2 hours
-10°C temperature in the mould (ice-sensor)
8 RED
7 WHITE
6 SENSOR
5 SENSOR
1,51 liters per minute.
5 seconds = ~100cc (+/- 3cc)
2,07 bar till 8,27 bar
1,38 bar till 8,27 bar
42
Advertisement
Table of Contents
