Table of Contents
Advertisement
Reversing the door of your appliance
Caution! After unscrewing any of the fixing hinges, hold
the door to prevent it from falling and causing damage.
Any parts that you remove from the appliance whilst
reversing the door, should be retained for later use.
o WHILST SUPPORTING THE DOOR. Unscrew the upper hinge
screws.
o Remove the door from the bottom hinge.
o Unscrew the leg holder fixing screws.
o Unscrew the three screws fixing the bottom hinge and then fix
the bottom hinge on the opposite side.
o To fit the door on the opposite side of the freezer proceed with
the above procedure in reverse.
o On the bottom side of the
door
unscrew
stopper screws and remove
the stopper (A). Fix the
attached stopper with its
bearing
on
the
side of the door.
o Unscrew the forced door
closure system (B) and fix
it
to
the
opposite
of the door (certain models
only).
o Tilt the appliance backward
at a maximum angle of 35°
Unscrew the leg support
screws (C) - left and right,
and
remove
support cover (D). Then
place it on the opposite
side. Unscrew, remove and
then replace the position of
the end switch (E) and
decorative
peg
models with forced door
closing system).
the
swing
opposite
side
the
leg
(F)
(for
23
Advertisement
Table of Contents
