Advertisement
2. Mount the Control Station
Model 900CS10-00
Step
ATTENTION
If the 900 Control Station is replacing an existing product, contact your local Honeywell
representative for instructions.
1
Using the drawing below, cut panel hole. You can use the cardboard template as a rough guide but
be sure to measure against the drawing below before cutting. Drill holes using a 3/16 inch (4.76mm)
size drill bit. Remove any loose material from the mounting cut-out to prevent that material from
falling into the Control Station during installation.
2
Mount the gasket by placing its 14 holes over the Control Station's 14 mounting bolts. Push gasket all
the way on to the mounting bolts. Insert Control Station into panel cutout.
3
Install the 14 kep nuts provided with the Control Station. Tighten evenly for uniform gasket
compression. Do not tighten the kep nuts beyond a maximum of 17 inch-pounds (1.92 N-m) or you
may cause damage to the Control Station's front panel.
Page 4 of 14
Action
51-52-33-157 Rev. 6
Hide quick links:
Advertisement
