Mitsubishi Electric MELSEC FX2NC-16MT-D/UL Hardware Manual page 73

FX2NC Series Programmable Controllers
Three types of power cables shown below are offered.
unit, and C is offered with an input extension block.
Table 4.3 :
Type
Power cable for main unit
A
Input power cable for input extension
B
block
Input power cable for input extension
C
block (for crossover wiring)
The crossover cable
power to an input block beyond four output blocks, use the cable
For the 24V DC power source of the FX or FX
rection value should be written in data register D8008; a special data register that sets the
power failure detection period. However, for the FX
is not necessary to write the correction value.
The data stored in the D8008 register will be automatically corrected by the system pro-
gram. Do not modify the D8008 data.
Application
C
can be wired across up to four 16-point output blocks. To supply the
A
and
Model name Length
FX -100MPCB 1m(3.3ft)
2NC
FX -100BPCB 1m(3.3ft)
2NC
FX -10BPCB1
0.1m(0.3ft) Input extension block
2NC
series programmable controllers, the cor-
2N
series programmable controllers, it
2NC
Power supply 4.
B are offered with the main
Product in same
package
Main unit
B
.
4-3