Top Side Of The Xpad L10; Preparing The L10 Tablet For First Use; Inserting A Sim Card - Xplore iX101L1 User Manual

Top Side of the XPAD L10

Barcode scanner
button
Pen Holder

Preparing the L10 Tablet for First Use

This section has steps for setting up the L10 platform for the first use.

Inserting a SIM Card

If your L10 tablet is enabled with Wireless Wide Area Networking (WWAN), you need an activated
SIM card in the SIM card holder to access the cellular data network. The SIM holder is located in the
battery bay of the L10 and can hold one or two Nano SIMs (4FF).
The L10 supports two SIM cards and switching between SIMs is done within Windows. Most people
will need only one SIM. To add or change a SIM, follow these instructions:
1. Shut down and turn off the tablet.
2. Remove the battery if it is in the tablet.
3. Pull out the SIM holder shown above.
4. Put your SIM card into the slot with the contacts facing down ensuring the notched edge
5. Then put the frame back into its port and return the battery to its bay.
See also
Chapter 1 Getting Started
Pen Holder
Press to activate the barcode scanner (if installed)
Holds the long pen when not in use
on the card aligns with the notched edge in the holder.
Inserting a SIM Card on page 22
Docking
connectors
Preparing the L10 Tablet for First Use
Barcode scanner
button
SIM card holder
9