ASD FieldSpec 3 User Manual page 35

www.asdi.com
Step 13
Figure 2-23
Step 14
Step 15
Step 16
Step 17
Step 18
ASD Document 600540 Rev. J
The pistol grip holder provides a convenient location for the pistol grip to be
stored when not in use.
Placing velcro strips on the laptop carrier and instrument controller.
With the hook and mesh velcro still mated, remove the backing from the
adhesive side on the mesh side of one strip.
Recall the placement of the instrument controller on the laptop carrier from
Step 6. Set the instrument controller onto the exposed adhesive of the mesh
side of the velcro. Press down firmly.
Gently separate velcro of the instrument controller from that of the laptop
carrier. Smooth over the velcro strips on both the instrument controller and
laptop carrier.
Repeat from Step 14 for the other velcro strip.
The end result is shown in
The laptop carrier is equipped with a pistol grip holder on the right-hand side.
The pistol grip holder can be unscrewed and moved to the left-hand side of
the laptop carrier, if necessary. It is recommended that the pistol grip holder
is removed when storing the laptop carrier in the shipping trunk.
25
Figure 2-25.
FieldSpec® 3 User Manual
Chapter 2 Setup