Panasonic AJ-YDX30G Operating Instructions Manual page 6

7
Remove one screw (B), and first remove the
INT CONNECT board, then remove the
BACKEND board. At this time, be careful not
to touch the side contacts.
Side contacts
BACKEND board
8
Insert the connector of this board into the
connector of the BACKEND board removed
7
in .
This board
Connectors
9
Fasten the BACKEND board and this board
with four screws (supplied).
Screws (supplied)
10
Insert the BACKEND board into the original
position, and fasten with the screw (B) at
the position removed in step
E-5
Screws (B)
INT CONNECT board
BACKEND board
Side contacts
4
.
11
Insert the INT CONNECT board into the
original position, and fasten with the screw
(B) at the position removed in step
When inserting these boards, do so slowly
so that they are inserted straight without
tilting. Also be careful not to pinch cables.
If the boards are inserted tilted, then the
camera recorder may have recording problems
etc.
12
Return the PB COVER to the original
position, and fasten with the screws (B) at
the positions removed in step
13
Return the side panel to the original
position, and fasten with the screws (A and
C) at the positions removed in steps
5
and .
<Notes>
Be careful not to put load on the wires or
connectors when you attach the L side
panel.
When you attach the R side panel,
handle the cords as shown below.
<Note>
Use the +No.2 screwdriver for removing and
attaching of the screws (A), and +No.1
screwdriver for the screws (B) and (C).
7
.
6
.
2 3
, ,