How To Set Up Central Control Address Number - Toshiba RAV-RM301SDT-E Service Manual

6. External view of P.C. board assembly
7. Address setup
In addition to set up the central control address, it is necessary to change the indoor unit number.
(Line/Indoor/Group address). For details, refer to 1:1 model connection interface Installation Manual.

10-3. How to Set up Central Control Address Number

When connecting the indoor unit to the central control remote controller using 1:1 model connection interface,
it is necessary to set up the central control address number.
• The central control address number is displayed as the line No. of the central control remote controller.
How to set up from indoor unit side by remote controller
<Procedure> Perform setup while the unit stops.
1
Push + buttons for 4 seconds or more.
When group control is executed, first the unit No. is displayed and all the indoor units in the group control
are selected. In this time, fans of all the selected indoor units are turned on. (Fig. 1)
ALL
(Keep displayed status without pushing
In case of individual remote controller which is not group-controlled, Line address and Indoor unit address
are displayed.
2
Using temperature setup
3
Using timer time
The setup data is shown in the table below (Table 1).
4
Push button. (OK if display goes on.)
• To change the item to be set up, return to Procedure
5
Push button.
The status returns to usual stop status.
(Table 1)
SET DATA Central control address No.
0001
0002
0003
:
0064
0099 Unset (Setup at shipment from factory)
Terminator (SW01)
85
UNIT LOUVER
buttons, specify CODE No.
buttons, select the SET DATA.
1
2
3
:
64
– 79 –
button (button of the left side).)
03 03 03 03 03
.
2
.
SET DATA SETTING
TEMP.
2
TIMER SET
1
FILTER
RESET TEST
5
52
(Fig.1)
CODE No.
UNIT No.
R.C. No.
ON / OFF
FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
3
1
4