Detachments - Toshiba RAV-RM301SDT-E Service Manual

12. DETACHMENTS

WARNING
Be sure to stop operation of the air conditioner before
work and then turn off switch of the breaker.
No. Part name
1. Detachment
Air Filter
1
2. Attachment
1. Detachment
Plate inlet-A
2
Plate inlet-B
2. Attachment
Procedure
1) Push knobs (3 positions) of the air filter hooks
toward the arrow direction to remove the air
filter.
1) Insert the air filter surely into the hooking
grooves (4 positions) at the opposite side of
the hooks, and then fix it to the original
position.
NOTE)
In case of sucking system from bottom side,
installation direction is determined. Install the air
filter so that hooks are aligned at discharge side.
1) Take off fixing screws while holding the plate
inlet-A with hands to remove it.
(Sucking system from rear side: Ø4 × 10, 8 pcs)
(Sucking system from bottom side:
Ø4 × 10, 11 pcs)
2) Take off fixing screws while holding the plate
inlet-B with hands to remove it.
(Ø4 × 10, 6 pcs)
NOTE)
Be careful that sheeting metal does not fall when
removing the plate inlet.
1) Using the screws taken off in procedure 1. 2) of
2
, attach the plate inlets in order of B
→ A while holding them not to fall down.
CAUTION
Be sure to put on gloves during working time;
otherwise an injury will be caused by a part etc.
[In case of sucking system from rear side]
[In case of sucking system from bottom side]
[In case of sucking system from rear side]
Plate inlet-A: 8 screws Plate inlet-A: 8 screws Plate inlet-A: 8 screws
[In case of sucking system from bottom side]
Plate inlet-B: 6 screws Plate inlet-B: 6 screws Plate inlet-B: 6 screws
– 87 –
Remarks
Air filter Air filter Air filter
Hook Hook Hook
Air filter Air filter Air filter
Push Push Push
Hook Hook Hook
Plate inlet-B: 6 screws Plate inlet-B: 6 screws Plate inlet-B: 6 screws
Plate inlet-A: 11 screws Plate inlet-A: 11 screws Plate inlet-A: 11 screws
Push Push Push