Advertisement
Quick Links
Download this manual
See also:
User Manual
M (Mitel design) is a registered trademark of Mitel Corporation. ©2007, Mitel Corporation.
All other products and services are the trademarks of their respective holders. All rights reserved.
Note: For more information about using programmable keys and other features on your 5302 IP
Phone, refer to 5302 IP Phone User Guide located at http://edocs.mitel.com or contact
your administrator.
Configuring your Directory Number
(DN) and PIN
If all 3 LEDs are flashing after power-up or
reset, the DN must be entered using the dial
pad, followed by the '#' key. Then,
optionally enter a PIN followed by the '#'
key. If you do not need to enter a PIN. just
press the '#' key.
Phone Key Features
Make a Call
12
Lift handset.
1
Dial number.
1
Press the # key to indicate the end of
dialing or wait for the call to connect.
Receive a Call
12
Lift the handset.
If the handset is already off hook,
8
9
or
Press the flashing line key.
End a Call
12
Replace the handset.
Place a Call on Hold
7
Press
. The LED next to the
held line number will flash.
Retrieve a Call on Hold
8
9
or
Press the flashing line key.
Retrieve a Message
12
Lift handset
1
Dial the voicemail number, OR
4
Press the programmed message key.
Follow the prompts to retrieve your
message.
Transfer a Call
6
Press
, then dial the transfer
destination number.
12
Hang up when you hear ringing or
wait for an answer, announce the
call, then hang up.
Conference Call
First call is established.
6
Press
, dial the number of the
third party when you hear dial tone,
then wait for an answer.
6
Press
.
1
Dial the conference feature access
code when you hear dial tone.
Adjust Handset or Speaker Volume
12
Lift handset.
10
11
or
Press volume up
volume down
repeatedly.
Speaker volume is changed if a paging
call is playing.
Adjust Ringer Volume
10
11
or
Press volume up
volume down
repeatedly.
while ringing.
or
or
Advertisement
