Schwinn 411 Assembly Manual / Owner's Manual page 33

Condition/Problem
Resistance does not
change (machine turns on
and operates)
Console shuts off (enters
sleep mode) while in use
Unit rocks/does not sit
level
Foot pedals loose/unit
dif cult to operate
Drive train click/tick
noise once per full crank
revolution
Knocking sound during
machine operation
Things to Check
Check Console
Check data cable integrity
Check data cable
connections/orientation
Check Servo Motor
(requires shroud removal)
Check electrical (wall)
outlet
Check connection at front
of unit
Check data cable integrity
Check data cable
connections/orientation
Reset machine
Check magnet position
(requires shroud removal)
Check Speed Sensor
(requires shroud removal)
Check leveler adjustment
Check surface under unit
Hardware
Check crank/pulley
assembly
Check foot assemblies,
leg assemblies, handlebar
assemblies
Check for loose hardware
Check hardware at
junction between Lower
Handlebar Arms, Pedals,
and Legs
Check for visual sign that Console is damaged. Replace Con-
sole if damaged.
All wires in cable should be intact. If any are visibly crimped or
cut, replace cable.
Be sure cable is connected securely and oriented properly.
Reseat all connections. Small latch on connector should line up
and snap into place.
If magnets move, adjust until they are within the proper range.
Replace Servo Motor if not functioning properly.
If the above steps do not resolve the problem, contact Cus-
tomer Service (if inside US/Canada) or your local distributor (if
outside US/Canada) for further assistance.
Make sure unit is plugged into a functioning wall outlet.
Connection should be secure and undamaged. Replace
adapter or connection at unit if either are damaged.
All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Magnet should be in place on pulley.
Speed sensor should be aligned with magnet and connected to
data cable. Realign sensor if necessary. Replace if there is any
damage to the sensor or the connecting wire.
Adjust levelers until machine is level.
Adjustment may not be able to compensate for extremely un-
even surfaces. Move machine to level area.
Tightly secure all hardware on the Pedal Arms and Handlebar
Arms.
Disconnect left and right foot assemblies and rotate crank. If
sound persists, replace crank/pulley assembly. If sound does
not come from rotating crank, check foot assemblies and up-
per/lower handlebars.
Manually move foot, leg, and handlebar assemblies to isolate
sound. Replace part making sound.
Tightly secure all hardware on the Stabilizers and the base of
the Console Mast.
Make sure that the hardware is clear of any debris.
Solution
33