Table of Contents
Advertisement
Black Waste Tank Flush Inlet
(Located on right sidewall)
19. Turn the water on to begin flushing. Allow
water to run for about three minutes.
20. Disconnect garden hose from flushing
system, allow water to drain from port, then
replace cap.
21. Close waste tank drain valves and refit the
dust cap onto the sewage drain outlet.
This will inhibit rust formation on valve shafts
and prevent entry and contamination by
airborne debris, insects, and rodents.
22. Continue with Step 2 - Antifreeze Fill
Procedure.
Step 2 – Antifreeze Fill Procedure
(Fill plumbing lines with RV water system
antifreeze)
NOTE: Non-Toxic RV water system antifreeze is
available from your dealer and from
most RV supply stores and national retail
outlets.Follow directions on the
container to determine the correct
amount to use for your motorhome.
WA RNING
NEVER use automotive antifreeze/
coolant in your RV water system.
Automotive coolant/antifreeze contains
ethylene glycol which, if ingested, can
cause blindness and can be fatal.
Your motorhome is equipped with a manually
operated waterline winterization system for your
convenience in winterizing fresh waterlines.
The system features a Winterization (diverter)
valve with an antifreeze siphon tube to draw non-
toxic RV water system antifreeze into the
waterlines. There is also a Water Heater Bypass
valve to avoid filling the water heater with
antifreeze.
23. Place Water Heater Bypass valve handle in
BYPASS position.
24. Insert the end of the siphon tube into a pail or
other container with 2 to 3 gallons of non-
toxic RV antifreeze solution.
• Winterization Valve
• Antifreeze Siphon Tube
Antifreeze Siphon Tube/Winterization Port
(See "Water System Drain Valve Locations"
chart at the end of this section for location on
your model)
SECTION 7 –
PLUMBING
7-19
Advertisement
Table of Contents
