Table of Contents
Advertisement
NOTE: If Waste Pump stalls, check breaker in
the load center. If problem persists,
remove black plug and motor shaft
access plate; then manually turn pump
shaft (located on the end of the Waste
Pump) with a screwdriver.
Further Information
For further Waste Pump operating and
troubleshooting information, see the
manufacturer's user guide provided in your
InfoCase.
Dumping Holding Tanks
(Model 59G)
1. Remove sewage drain hose from storage
compartment (located on left sidewall).
Sewage Drain Hose
(Located on left sidewall)
-Typical View
2. Remove dust cap from sewage drain outlet
and connect sewage drain hose. Be sure it is
firmly attached.
Sewage Drain Outlet
(Located beneath motorhome)
*Model 59G
3. Place the outlet end of sewage drain hose into
disposal opening.
NOTE: Black and Gray Waste Tank Drain valve
positions may be reversed, depending on
floorplan and tank location.
4. Open the Black Waste Tank Drain valve with
a quick pull and make sure there are no sags in
the hose. Close Black Waste Tank Drain valve
as soon as tank is empty.
• 1st - Pull Black Waste Tank Drain
valve to drain black water
(sewage tank, then close)
• 2nd - Pull Gray Waste Tank Drain valve to
drain gray water (sink/shower, then close)
Black and Gray Waste Tank Drain Valves
(Located beneath motorhome)
*Model 59G
NOTE: DO NOT OPEN BOTH VALVES AT
ONCE. Do not open the Gray Waste
Tank Drain valve until the black tank is
drained and dump valve closed to avoid
sewage back-up into gray tank. Gray
water also rinses any black water solids
from the sewage drain hose.
5. Open the Gray Waste Tank Drain valve. Be
sure there are no sags in the hose to ensure
complete drainage. Press and Hold Waste
Pump switch until tank is empty (do not run
pump dry.) Close Gray Waste Tank Drain
valve as soon as tank is empty.
NOTE: Sound of Waste Pump will change
significantly when tank is empty.
SECTION 7 –
PLUMBING
7-11
Advertisement
Table of Contents
