Control Descriptions - Jacobsen R-311T Dealer's Manual

2.2

CONTROL DESCRIPTIONS __________________________________________________

A. Tilt Steering Lever
Pull lever up to release steering column. Tilt
column up or down to position desired. Release
lever to lock steering column in place.
Never adjust steering while mower is moving. Stop unit
and engage parking brake switch before adjusting.
B. Traction Pedal
Press front of pedal (B
Release pedal to slow mower and stop.
Press rear of pedal (B
Release pedal to slow mower and stop. Allow mower to
come to a complete stop before reversing directions.
NOTICE
Engine will stop if traction pedal is depressed in either
direction with the parking brake engaged.
Disengage parking braked before attempting to drive
mower.
C
3
Transport Speed
C. Mow Speed Stop
Limits forward speed while mowing. To operate at lower
travel speed while mowing, rotate lever (Position C
so it contacts stop screw on floor board when forward
travel pedal is pressed. To travel at full speed, set lever
in position shown (Position C
be adjusted to set specific mow speeds. See Parts &
Maintenance Manual.
!
CAUTION
) down for forward travel.
1
) down for reverse travel.
2
C
1
C
2
B
1
B
2
Mow Speed
Figure 2A
). Stop screw (C
3
D. Brake Pedal
Press pedal down to slow or stop the machine and to
disengage cruise control. Never press both service
brake pedal and traction pedal at the same time.
E. Parking Brake Lock/Release
To lock parking brake, hold brake pedal (C) down and
press lock (E
brake pedal release (E
F. Weight Transfer
Used to adjust the ground pressure of the decks. See
Parts & Maintenance Manual.
G. Seat Tilt Lever
Used to adjust the rear seat angle. Lift up on lever and tilt
seat back as required until seat is in the desired
position. Release the lever to lock the seat in position.
H. Transport Latches
Used to prevent accidental lowering of the wing cutting
units during transport.
I. Horn/Test Switch
Used to sound horn and test system warning lights.
Depress switch, horn should sound and all warning
lights, except for glow plug, engine oil and charge
pressure, should light.
)
1
) can
2
CONTROLS 2
E
1
D
E
2
) until it engages. To disengage, press
1
).
2
Figure 2B
en-7