Adjusting The Seat Belts; Locking; Front Seat Belts Not Fastened Warning Light; Adjusting The Front Seat Belt Height - Fiat TALENTO Owner's Handbook Manual

adjust the head restraint. For
maximum safety, the distance between
the head and headrest must be
minimum;
adjust cushion (seat) height. This
adjustment optimises visibility;
adjust the steering wheel.

ADJUSTING THE SEAT BELTS

Sit firmly on the backrest.
The chest belt 1 fig. 173 must be as
close as possible to the neck without
touching it.
The waist belt 2 fig. 173 must be
resting on the thighs and against the
pelvis.
The belt must adhere as much as
possible to the body. (e.g. avoid
wearing clothes that are too bulky or
placing obstacles between the body
and belt).
173
94

Locking

Pull out the belt slowly without forcing it
and insert the tab 3 fig. 174 into the
buckle 5 (make sure it is locked by
pulling the tab 3).
174
Repeat the operation if the seat belt
blocks.
If the belt is completely blocked, pull
slowly but firmly and draw out at least
3 cm. Let it rewind normally then pull it
out again. If the problem persists,
contact a Fiat Dealership.
Front seat belts not fastened
warning light
This is on the central display and turns
on when the engine is started. Then, if
the seat belt is not fastened and the
vehicle reaches 16 km/h, it flashes and
an acoustic warning turns on for about
2 minutes.
T13622
Depending on the vehicle, it flashes if
the front passenger seat belt is not
fastened.

Adjusting the front seat belt height

Move the lever 6 fig. 175 to select the
adjustment position so the chest belt 1
fig. 173 adheres to the body as
described above.
175
T13622-1
After adjusting, make sure it is properly
locked in place.
Unlocking
Press button 4 fig. 174, the belt
rewinds. Accompany it as it rewinds.
Rear side belts
For the first row in the rear, you must
use belts 8 fig. 176;
for the last row at the rear, you must
use the seat belts 7 fig. 176.
When the seat belt 8 fig. 176 is not
worn, insert the tab 9 into the buckle
10.
T36553