Start & Stop System; Operating Mode; Activation And Deactivation Of The System - Fiat TALENTO Owner's Handbook Manual

Table of Contents

Advertisement

The steering is thus less stiff when
parking (for greater comfort), but it gets
stiffer as driving at high speeds).
WARNING
26) Adjustments must be carried out only
with the vehicle stationary and the engine
off.
27) Never stop the engine when going
downhill, and in general when the vehicle is
moving (turning the engine off disengages
the power steering).
28) It is absolutely forbidden to carry out
any after-market operation involving the
steering system or steering column
modifications (e.g. installation of anti-theft
device) that, in addition to invalidating the
warranty, could adversely affect
performance, cause serious safety
problems and also result in the car not
meeting type-approval requirements.
IMPORTANT
1) You will still be able to turn the steering
wheel with the engine off or in the event of
a system fault. You need to apply more
effort.
32
START&STOP
SYSTEM
29) 30)
This system lets you reduce fuel
consumption and harmful gas
emissions. When you start the vehicle,
the system is automatically activated.
When driving, the system stops the
engine (in stand-by) while the vehicle is
not moving (traffic jam, stop for a traffic
light, etc.).

OPERATING MODE

The engine is put in stand-by if:
the vehicle was driven since its last
stop;
the gear is in neutral;
the clutch pedal is released;
the vehicle speed is lower than about
3 km/h.
2) 3)
The warning light
shown on the
instrument panel indicates that the
engine is in standby.
The equipment of the car remains
functioning for the entire time the
engine is off.
The engine is automatically restarted
when the clutch pedal is pressed and
the vehicle is put in gear.
ACTIVATION AND
DEACTIVATION OF THE
SYSTEM
Press button 1 fig. 65 to deactivate the
function. The dedicated message will
appear on the instrument panel and the
warning light 2 fig. 65 on the button will
turn on.
Pressing again will reactivate the
system. The appropriate message will
appear on the instrument panel and the
warning light 2 on the button 1 will turn
off.
65
The system re-activates automatically
whenever the vehicle is voluntarily
restarted (refer to the "Starting the
engine" paragraph in the "Starting and
driving" chapter).
NOTES: With the engine in stand-by,
press button 1: the engine restarts
automatically.
T36535

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents