Tyre Inflation Kit; Precautions For Using The Kit - Fiat TALENTO Owner's Handbook Manual

TYRE INFLATION KIT

264
179)
31) 32) 33) 34) 35) 36) 37)
To take the kit out, move the seat as far
forward as possible and lower the
backrest.
265
Undo the tool bag fixing screw C
fig. 265 and then turn the bag to
remove it.
158

Precautions for using the kit

The kit must not be used for more than
15 consecutive minutes.
T32788
266
With the engine started and the
handbrake engaged;
unwind the hose from the canister;
connect compressor hose 3
fig. 266 to the canister 8,
depending on the versions, connect
or screw in canister 8 to the
compressor where there is a hollow 7
fig. 266;
unscrew the tyre valve cap involved
and screw the inflation hose 1 fig. 266;
disconnect all the accessories
previously connected to the accessory
socket;
only connect plug 2 fig. 266 to the
T36718
vehicle's accessory socket;
press switch 4 fig. 266 to inflate the
tyre to the prescribed pressure (refer to
the "Tyre inflation pressure" paragraph
in the "Maintenance and care" chapter);
after 15 minutes at most, stop
inflating;
NOTE While emptying the canister
(about 30 seconds), the pressure gauge
5 fig. 266 briefly indicates a pressure of
up to 6 bar, then it goes back down
again.
adjust the pressure: to increase it,
continue inflating the tyre with the kit; to
lower it, press button 6 fig. 266.
T35749
If after 15 minutes a minimum pressure
of 1.8 bar has not been reached, it
means that you cannot repair the tyre;
do not drive and contact a Fiat
Dealership.
Once the tyre is correctly inflated,
remove the kit: slowly unscrew the
inflation hose of the canister 1
fig. 266 to avoid splashes of product
and replace the canister in a plastic
package so the product does not leak
out.
Attach the instruction label on the
dashboard where the driver can see it;
replace the kit in the tool bag and put
it back under the driver's seat;
when the first inflation has been
done, the tyre will continue to lose air
and you need to start driving again to
plug the hole;