Fiat TALENTO Owner's Handbook Manual page 114

The following table has the same information as the previous diagram to show how to respect current laws.
Child restraint
systems
Transverse cot
Group 0
Child restraint
seat facing
backwards
Groups 0 and 0+
Child restraint
seat facing
backwards
Groups 0 and 1+
Child seat
facing forward
Group 1
Booster seat
Groups 2 and 3
X: seat not authorised to install a child restraint of this type.
U: seat allowing fastening with seat belt for an approved child seat like "Universal"; check possible installation.
(2): position the vehicle's seat as far back and as high as possible, then slightly incline the backrest (about 25°).
(3): the cot is installed crosswise with respect to the vehicle and takes up at least two seats. The child's head must be opposite
the vehicle's door.
(4): move the front seat as far forward as possible to install the child seat backwards from driving direction, then move it back
to maximum so it does not come into contact with the child seat.
(5): child seat facing forward: position the child seat backrest in contact with the seat backrest. In any case, remove the rear
seat headrest that the child seat is positioned against. This should be done before positioning the child seat (please see the
paragraph "Rear headrest" in chapter "Knowing your vehicle"). Do not move the seat in front of the child back more than half
the distance and do not incline it more than 25°.
112
The child's Front passenger
weight seat (1) (2)
< to 10 kg X
< to 13 kg U
< to 13 kg and
U
from 9 to 18 kg
from 9 to 18 kg X
from 15 to 25 kg
and from 22 to U
36 kg
Combi/bus version 8 seats
Side 2nd row Centre 2nd row
U (3)
U (4)
U (4)
U (5)
U (5)
Rear seat
Side 3rd row
U (3) U (3)
U (4) U (4)
U (4) U (4)
U (5) U (5)
U (5) U (5)
Centre 3rd row
U (3)
U (4)
U (4)
U (5)
U (5)