Additional New Effect Types - Yamaha MONTAGE 6 Supplementary Manual

Additional New Effect Types

The MONTAGE offers following new effect types.
Effect Type Description
Rotary Speaker 2 Simulator of a rotary
speaker including
the amp block.
Effect Type Description
Uni Comp Down Compressor using
"downward"
algorithm for making
loud sounds quieter.
MONTAGE Supplementary Manual
Parameter Description
Speed Control Switches the rotary speed.
Drive Controls the amount of the distortion.
Tone Adjusts the tone level.
R/H Balance Determines the volume balance of the horn (higher range) and rotor (lower range).
Output Level Determines the output level of the effected sounds.
Mic L-R Angle Determines the L/R angle of the microphone.
Input Level Determines the input level.
Mod Depth Determines the depth of the modulation.
Horn Slow/Fast Determines how long it takes for the rotation speed of the horn (higher range) to change from
Slow to Fast when the rotation speed is switched.
Horn Fast/Slow Determines how long it takes for the rotation speed of the horn (higher range) to change from
Fast to Slow when the rotation speed is switched.
Rotor Slow Determines the frequency of the rotor (lower range) when the Speed Control is set to Slow.
Horn Slow Determines the frequency of the horn (higher range) when the Speed Control is set to Slow.
Rotor Fast Determines the frequency of the rotor (lower range) when the Speed Control is set to Fast.
Horn Fast Determines the frequency of the horn (higher range) when the Speed Control is set to Fast.
Rtr Slow/Fast Determines how long it takes for the rotation speed of the rotor (lower range) to change from
Slow to Fast when the rotation speed is switched.
Rtr Fast/Slow Determines how long it takes for the rotation speed of the rotor (lower range) to change from
Fast to Slow when the rotation speed is switched.
Parameter Description
Threshold Determines the minimum input level at which the compressor effect is applied.
Knee Determines how the transition range changes around the threshold. The higher the value, the
shallower the transition curve.
Attack Determines the amount of time it takes for the effect to reach its maximum compression.
Release Determines the amount of time it takes for the compressor effect to diminish or fade out.
Ratio Determines the ratio of the compressor.
Side Chain EQ When this is turned on, the EQ is applied for the corresponding input level range of the Side
Chain.
SC EQ Q Determines the Side Chain EQ bandwidth.
SC EQ Freq Determines the center frequency of the Side Chain EQ.
SC EQ Gain Determines the level gain of the Side Chain EQ.
Dry/Wet Determines the balance of the dry sound and the effect sound.
Output Level Determines the output level of the effected sounds.
Make Up Gain Determines the output gain of the compressor block.
Post-comp HPF Determines the Cutoff Frequency of the High-Pass Filter which follows the compressor.
Clipper Determines the extent to which the Clipper is applied for forcibly reducing the gain.
Clipper Source Determines the signal to which the Clipper effect is applied for forcibly reducing the gain.
Side Chain Lvl Determines the Side chain input level.
Uni Comp Down
Output
Ratio: 1.0
Ratio: 2.0
Ratio: 4.0
Threshold
Input
22