Source Select; Picture Controls - Runco Reflection DR-300 Owner's Operating Manual

SOURCE SELECT

Source Select
RGB
Video
S-Video
PC Card Viewer
There are two options for selecting a source. You may either press one of the source buttons on the
remote, or by pressing MENU and highlighting SOURCE SELECT. When the SOURCE SELECT
menu appears, highlight the desired source and press either the right arrow or the ENTER button.
The RGB input will also accept component. For example, you could input a progressive DVD or HDTV
component signal into this port (using a VGA-RGB cable). If using component, only the red, green
and blue cables need to be used on the VGA-RGB cable; the sync cables need not be connected.
However, if you will be switching between RGB and component sources, ensure all five cables
(R,G,B,H,V) are connected.
The projector will automatically detect whether a signal is component or RGB. Therefore, no com-
mand(s) need to be sent to the projector to tell it to change from one to the other.
PICTURE
Main Menu
Aspect Ratio
Source Select
Picture
Image Options
Color Management
Projector Options
Tools
Help
The picture menu is where image quality adjustments can be made. These include contrast, bright-
ness, Color, Hue (Tint) and Sharpness.
Note: Color, Hue and Sharpness do not function when an RGB signal is input. Sharpness will not
function when a Component signal is input.
Picture
Brightness
Contrast
Color
Hue
Sharpness
12